No-Bolt assembly

Metalware’s No-Bolt Interlok steel shelving is a snap to assemble.

Click here to download the installation sheets in PDF format.

1. Installing a shelf clip on a “T” upright (one-way locking)

Take a shelf clip and hold the longer end up. Insert the longer end first on the “T” upright at the desired slot height. Place the shorter bottom end in the slot directly below.

2 . Installing 2 shelf clips on a “T” upright (two-way locking for placing an add-on unit)

Place shelf clip in the opposite direction (as in the previous step) in the same slot.

3. Installing a shelf

Place 1 shelf clip (as in step 1) at the desired height on all 4 “T” uprights. Place a shelf so that each corner slides over a shlf clip. Press the shelf down firmly to allow it to lock in between shelf clips and “T” uprights.

4. Installation of Side Brace

Bolt side brace in an “X” style halfway up the “T” upright.

5. Installation of Back Brace

Adjust angle of back brace to appropriate angle and bolt halfway up the reverse side of the shelving unit.